Colle à revêtement

Compared to the Free Chack Pro, the consistency has been optimized. This results in a shortened drying time. This achieves immediate 100% adhesion to the surface of the blade. 

This means that the racket is as powerful as possible immediately after assembly. The noticeably longer ball contact time and the increased rotation support the player immediately. 

 

• Shake before use
• Requires less glue to adhere the rubber to the blade
• Requires a little longer time to dry
• Does not dry as clear

• 50ml & 10 sponges
• 90ml & 16 sponges
• 500ml & 48 sponges

• Newly formulated, water based adhesive
• Specifically designed for Spring Sponge rubbers; SpinArt and the Tenergy series of rubbers
• Allows easy removal of excess glue from sponge and blade surface
• Stronger bond than Free Chack

• Colored racket sheets
• Adhesive back
• For penhold blades

• Length = 164 feet (50 meters)
• Width = 3.9" (10 cm)

• For optimal removal of glue residue on blade and sponge surfaces
• The yellow foam sponge removes glue residue from the surface of the wood
• The blue brush enables glue residue to be freed and then removed in small quantities (must use constant vertical motion)
• Intended for use with Butterfly Free Chack (the Butterfly Remover is not guaranteed to work on all rubbers)

• Sticky on one side
• Prolongs the life of the rubber
• Contains two sheets

• Step 1 - Clean the surface of the rubber with a special rubber cleaner and dry well.
 

• Step 2 - Peel off the rubber protective adhesive film (hereafter referred to as the film) from the backing paper (separator), and slowly attach the rubber surface and the adhesive surface of the film so that air does not enter from the grip side to protect the rubber surface. Please note that the film has a front and back.
 

• Step 3 - If you trim off the excess film, it can be more difficult to remove.
 

• Step 4 - When using the racket, put the film removed from the rubber on the side of the backing paper (separator) that does not have writing on it and store it. If you apply the film to the side of the backing paper (separator) that has writing on it, the film may become unusable.

• Do not use for anything other than table tennis rubber.
• Do not rub the adhesive surface with your finger or paper.
• Do not place near fire.
• Do not fold or bend.
• Keep out of reach of children.

• Under some circumstances, adhesive may remain on the rubber depending on the surface condition of the rubber, how long it was attached and how it was stored.
• Avoid high temperature and humidity and store in a place not exposed to direct sunlight
• If the adhesive strength is decreased or the product has become dirty, replace with a new product.

• Length = 164 feet (50 meters)
• Width = 3.9" (10 cm)

Butterfly RDJ S4 Shakehand Table Tennis Racket | RDJ Series | Recommended For Beginning Level Players | International Table Tennis Federation Approved
The Butterfly RDJ S4 Shakehand Table Tennis Racket is designed to offer a great foundation for novice level players who are learning the basic strokes. Spryer offers good speed, spin and control for any style of play. The 1.9mm sponge will offer a bit more speed than the RDJS1 and RDJS2 models.

• Blade Construction: 5-Ply Wood
• Handle: Flared - Concave At The centre - The Most Popular Style
• Rubber: Spryer - Sponge Thickness (mm): 1.9 & Rubber: Spryer Sponge Thickness (mm): 1.9
• Recommended For Beginning Level Players
• International Table Tennis Federation Approved