Butterfly

• New sponge containing antibacterial material
• Soft sponge with sealable container

• Cleaning tool for all your pip rubber sheets
• Soft bristle brush

A protective film of the adsorptive type that protects against dust and dirt and prevents deterioration. Contains one sheet.

1. Clean the surface of the rubber with rubber cleaner and let it dry.
2. Peel off the Butterfly adsorptive protective film (hereinafter referred to as film) from the separator paper, and then remove the separator. Slowly attach the rubber surface and the adsorptive surface of the film so that air does not enter from the dull side. Protect the rubber surface. Please note that the film has front and back sides.
3. If you cut off the part that protrudes from the racket, it will be more difficult to peel off.
4. When you use on the racket, peel the film off from the rubber, and stick the film on the side of the separator paper that does not have a cautionary note. If you stick the film on the side of the separator paper with cautionary notes, the film may become unusable.

Can be used repeatedly.

• Do not use for anything other than table tennis rubber.
• Do not rub the adsorptive surface with your finger or paper.
• Do not place near fire.
• Do not bend it.
• Keep out of the reach of children.
• The colour of the adsorptive sheet may change depending on the surface condition of the rubber, the sticking period, and the storage condition.
• Avoid heat and humidity, and store in a place out of direct sunlight.
• If the adsorption power is reduced, wipe it gently with a soft cloth or sponge containing water. After that, let it air dry before using it.
• Adsorption power varies depending on the material condition, usage period, storage condition, etc. of the rubber.
• If you feel any abnormality on your skin during use, stop using it immediately.

A protective film of the adsorptive type that protects against dust and dirt and prevents deterioration. Contains one sheet.

1. Clean the surface of the rubber with rubber cleaner and let it dry.
2. Peel off the Butterfly adsorptive protective film (hereinafter referred to as film) from the separator paper, and then remove the separator. Slowly attach the rubber surface and the adsorptive surface of the film so that air does not enter from the dull side. Protect the rubber surface. Please note that the film has front and back sides.
3. If you cut off the part that protrudes from the racket, it will be more difficult to peel off.
4. When you use on the racket, peel the film off from the rubber, and stick the film on the side of the separator paper that does not have a cautionary note. If you stick the film on the side of the separator paper with cautionary notes, the film may become unusable.

Can be used repeatedly.

• Do not use for anything other than table tennis rubber.
• Do not rub the adsorptive surface with your finger or paper.
• Do not place near fire.
• Do not bend it.
• Keep out of the reach of children.
• The colour of the adsorptive sheet may change depending on the surface condition of the rubber, the sticking period, and the storage condition.
• Avoid heat and humidity, and store in a place out of direct sunlight.
• If the adsorption power is reduced, wipe it gently with a soft cloth or sponge containing water. After that, let it air dry before using it.
• Adsorption power varies depending on the material condition, usage period, storage condition, etc. of the rubber.
• If you feel any abnormality on your skin during use, stop using it immediately.

With padded front and back panels and a zipper closure, this case makes sure your racket is protected. The inner tray that comes with it has been redesigned: it protects the racket more reliably and makes maintenance supplies easier to store.

• All new inner tray design: holds 1 racket, 2 40mm balls, and maintenance supplies
• Accessory pouch on inside panel
• Zipper closure
• Material: Polyester 320 denier
• Dimensions: 21 x 29 x 5 cm

The BD Tour Case II carries two rackets and four balls behind padded front and back panels.

• Tray divider with handle notch for two rackets and cut-outs for four balls
• Padded front and back panels
• Accessory pouch on inside panel
• Zipper closure and carry strap


• Dimensions: 30 x 21 x 4 cm
• Material: 320 Denier polyester

• Padded front and back panels
• Zipper closure and carry strap


• Material: 320 Denier polyester

A protective film that sticks to the rubber surface between sessions to prolong its life; two sheets per pack.

• Sticky on one side
• Prolongs the life of the rubber
• Contains two sheets

• Step 1 - Clean the surface of the rubber with a special rubber cleaner and dry well.
 

• Step 2 - Peel off the rubber protective adhesive film (hereafter referred to as the film) from the backing paper (separator), and slowly attach the rubber surface and the adhesive surface of the film so that air does not enter from the grip side to protect the rubber surface. Please note that the film has a front and back.
 

• Step 3 - If you trim off the excess film, it can be more difficult to remove.
 

• Step 4 - When using the racket, put the film removed from the rubber on the side of the backing paper (separator) that does not have writing on it and store it. If you apply the film to the side of the backing paper (separator) that has writing on it, the film may become unusable.

• Do not use for anything other than table tennis rubber.
• Do not rub the adhesive surface with your finger or paper.
• Do not place near fire.
• Do not fold or bend.
• Keep out of reach of children.

• Under some circumstances, adhesive may remain on the rubber depending on the surface condition of the rubber, how long it was attached and how it was stored.
• Avoid high temperature and humidity and store in a place not exposed to direct sunlight
• If the adhesive strength is decreased or the product has become dirty, replace with a new product.